Magtek JMTMacMS Applet Manual de usuario

JMTMacMS Applet for MagTek HID Card Reader Mac OSX PROGRAMMER’S GUIDE PART NUMBER 99875456-1 NOVEMBER 2009 Confidential This documen

JMTMacMS Applet Programmer’s Guide 6 SetCRStatus(value) JMTMacMS Applet calls this function to send the host status of HID reader. If reader is co

7 22. Card Reader ID 23. Encode Type 24. DUKPTKSN data 25. Session ID SetCardReadingError() If the card is swiped too fast or too slow or the ca

ii Copyright© 2001-2009 MagTek®, Inc. Printed in the United States of America Information in this document is subject to change without notice. No

iii SOFTWARE LICENSE AGREEMENT IMPORTANT: YOU SHOULD CAREFULLY READ ALL THE TERMS, CONDITIONS AND RESTRICTIONS OF THIS LICENSE AGREEMENT BEFORE INST

iv TABLE OF CONTENTS I. Introduction ...

1 I. INTRODUCTION JMTMacMS Applet transfers Card data from MagTek HID Card Reader device to a host program running on Mac OSX operating system. The

JMTMacMS Applet Programmer’s Guide 2 IV. JMTMACMS COMPONENT REQUIREMENTS The directory on the host Web Server must contain the following four comp

3 V. JAVASCRIPT API FUNCTIONS When a card is swiped through Card Reader device, the JMTMacMS Applet sends card data to the browser by calling se

JMTMacMS Applet Programmer’s Guide 4 SetTrack1Len(value) JMTMacMS Applet calls this function to send the host the length of track1 data. SetTrack2

5 SetTrack2MskData(value) JMTMacMS Applet calls this function to send the host track 2 data masked. SetTrack3MskData(value) JMTMacMS Applet ca