Magtek PORT POWERED SWIPE READER Manual de usuario

PORT POWERED SWIPE READER TECHNICAL REFERENCE MANUAL Manual Part Number 99875094 Rev 17 JUNE 2010 REGISTERED TO ISO 9001:2008

Port Powered Swipe Reader 4 SPECIFICATIONS Table 1-2 lists the specifications for the Port Powered Swipe Reader. Figure 1-3 shows the dimensions

Section 1. Features and Specifications 5 Figure 1-3. Dimensions

Port Powered Swipe Reader 6

7 SECTION 2. INSTALLATION The hardware installation consists of plugging the cable into the PC and optional 25-pin adapter, if required, Com Port

Port Powered Swipe Reader 8 Figure 2-1. Mounting Hole Dimensions for Surface 3. Mount the Reader. INSTALLATION AND TEST To install the Swip

Section 2. Installation 9 6. Select 8 data bits, no parity, 1 stop bit. (With the new version, this setting can be adjusted as required.) 7.

Port Powered Swipe Reader 10

11 SECTION 3. OPERATION Included in this section are Indicator, Card Read, Reader to Host Message Format, and a timing diagram of sign-on ID. LED

Port Powered Swipe Reader 12 TIMING FOR ID SIGN ON Timing for the ID Sign-on and transmission bursts (5 ms with 10 ms between bursts) are shown in

Section 3. Operation 13 Table 3-2 lists the available part number, firmware, and configuration. Table 3-2. Sign-on ID for Configurations Part

ii Copyright© 1997-2010 MagTek®, Inc. Printed in the United States of America Information in this document is subject to change without notice. No p

Port Powered Swipe Reader 14

15 SECTION 4. PROPERTIES AND COMMANDS A full set of properties and commands have been incorporated into the new version of the Port Powered Swipe

Port Powered Swipe Reader 16 RESET DEVICE The Reader will always be reset when power (DTR) is applied (hardware reset). It can also be reset prog

Section 4. Properties and Commands 17 CONFIGURATION COMMANDS The configuration properties are stored in three separate bytes (referred to as sw

Port Powered Swipe Reader 18 Switch A Switch A, Table 4-1, is primarily used to define the communication settings. The default for Switch A is: 1

Section 4. Properties and Commands 19 Switch B Switch B, Table 4-2, is used to define the bracketing characters that are used in the messages.

Port Powered Swipe Reader 20 Switch C Switch C, Table 4-3, is used to define the way a card is read. The default for Switch C is: 01010101 Enab

Section 4. Properties and Commands 21 As with the switch settings, the sentinel parameters can be discovered by sending the corresponding comman

Port Powered Swipe Reader 22

iii LIMITED WARRANTY MagTek warrants that the products sold pursuant to this Agreement will perform in accordance with MagTek’s published specifica

iv FCC WARNING STATEMENT This equipment has been tested and was found to comply with the limits for a Class B digital device pursuant to Part 15 of

v TABLE OF CONTENTS SECTION 1. FEATURES AND SPECIFICATIONS ---------------------------------------------------------------------- 1 MAGTEK DEVICE

vi Figure 1-1. Port-Powered Swipe Reader

1 SECTION 1. FEATURES AND SPECIFICATIONS The Port Powered Swipe Reader is a compact magnetic stripe card reader which conforms to ISO/ANSI standa

Port Powered Swipe Reader 2 FEATURES Major features of the Swipe Reader are as follows: • Powered through the RS-232 serial port – no external p

Section 1. Features and Specifications 3 Pin numbers and signal descriptions for the 9-pin (DE9) cable and 25-pin (DB25) adapter shown in the il